v0.1.3 AP Problems
-
-
@the-sledge I like you too :-)
-
@martyn Moving throttles back to near idle to maintain ~60% N2 (with DESC set on the TMS), and using SYNC mode to set VS. Previously I still had to use the speed brake a little bit to maintain 250 knot descent, otherwise it'd speed up a bit over time.
-
-
-
-
@martyn I'm encountering a possibly related issue in descent, using version 0.1.4. So far I have only been able to reproduce it when descending by more than 1000ft from the previously held altitude.
Steps to reproduce:
- Starting in ALT HOLD at 7000ft, LNAV, AP on
- Set ALT SEL to 2900ft, select ALT ARM => The horn sounds (not sure if that's supposed to happen)
- Status as shown by the annunciators is now: ALT HOLD (green), ALT HOLD armed (white).
- Select IAS, reduce thrust to idle (TMS set to DESC mode).
- About 400-500ft above the selected altitude, the aircraft will start to level off, reducing the descent rate to only about 200ft/m. IAS annunciator is still green, ALT annunciator is still white, but Airspeed starts to reduce rapidly. Adding thrust to keep airspeed at the desired value will cause the plane to keep a rate of descent of only about 50ft/m, while still indicating IAS green, ALT white.
- My current workaround when this occurs: Selecting VS mode, pitching down using SYNC, the AP will capture the selected Altitude as desired.
-
@martyn Tried it again today. Twice it worked perfectly. The third time it again went all haywire. At 22000feet, I set the target altitude to 16000feet and armed it, set VS mode, followed by SYNC switch (TOGGLE AFTERBURNER mapped to a switch on a keyboard), then set pitch down 1500feet/min. As soon as I pressed SYNC switch again, the vertical speed shot right up to +1500feet/min or more, then settled back down to zero. I tried this a number of times, then had to turn off the AP and hand-fly it down.
Guess I will submit a support ticket like you suggested. -
I can confirm these autopilot problems. Yesterday I made a flight without any problems (version 0.1.4) and today the autopilot did not wanted to descent. Plane used, 146 200
The first stage of the decent went well, from 23000 ft to 15000 ft. As I was almost at 15000 ft I had to go to 3000 ft. While I was still descending (about -500) I selected 3000, Armed, set VS, SYNC on set vs -2000, sync off. Autopilot did not keep vs, came back to 0. Tried a few times to set the vs, but did not work. So I did de descent manually. Plane used 146 300
-
@martyn I did another flight (by the way I am using the 100 version), but this time it worked perfectly. I will post screenshots the next time the problem occurs.
However, one thing I would like to note is that the instant I set a new altitude (6300ft) and armed it (current altitude was 16000ft), there was a long beep like when the altitude reaches within 1000ft of the target. Every time I had the AP problem, this beep has been there. But this time, AP descent worked perfectly.
