MJC8-Q400
-
Hi all
I recently purchased the pilot version of MJC8-Q400. I later updated it yo the Pro edition. All was well. I had to uninstall FSX-SE and re-install on a different drive. This meant re-installing all my payware aircraft. All was fine with other Just Flight products. However, MJC8-Q400, posed a problem. I tried to launch it in 'Ready For Take off mode' using the Control Panel (this had worked before the change) Now, it loads, but the engine doesn't start. I've followed the instructions. Still no joy.
I've done a re-install, and I'm mindful that there is a limit on this. Just wondering if, I've just got the Pilot edition? or there is a problem with the reinstall. This is in FSX SE. I have FSUIPC and Ezdok installed too. If this info helps
Please help
Thanks -
Hi all
I recently purchased the pilot version of MJC8-Q400. I later updated it yo the Pro edition. All was well. I had to uninstall FSX-SE and re-install on a different drive. This meant re-installing all my payware aircraft. All was fine with other Just Flight products. However, MJC8-Q400, posed a problem. I tried to launch it in 'Ready For Take off mode' using the Control Panel (this had worked before the change) Now, it loads, but the engine doesn't start. I've followed the instructions. Still no joy.
I've done a re-install, and I'm mindful that there is a limit on this. Just wondering if, I've just got the Pilot edition? or there is a problem with the reinstall. This is in FSX SE. I have FSUIPC and Ezdok installed too. If this info helps
Please help
Thanks
