MSFS24 - Autopilot Issue - Heading Hold Selects when Engaging Autopilot
-
Am I correct in assuming that when I turn on the Autopilot, it should wait for me to select what mode I want to apply, eg. Nav, Hdg, Alt etc. Currently it selects Hdg automatically, which can be disrupting, if you want say, Nav mode & the heading is not created in the HSI.
This issue was in an old thread (version 3.8 in MSFS20), but I don't know the outcome. Could someone advise me, if my assumption is correct & that it's working currently for them, or the software is designed to immediately engage Heading Hold, when firing up the Autopilot.
I have a Bravo controller using the native Microsoft Control Configurator. Pending a response, I am making further tests, although having spent a lot of time already on it.
Any help is appreciated.
Thanks.
-
@rcigliano Thank you for your helpful response, which I am now operating.
-
Altitude Hold can be engaged by pressing the white circle at the top right corner of the autopilot panel, or by triggering an "Altitude Hold" control assignment. Altitude Hold can be disengaged via the same methods, or it will be disengaged when vertical speed mode is engaged, or when the autopilot is disengaged.
Mark - Just Flight
-
Thanks Mark. So, Altitude Hold is not selected when the autopilot is engaged. Though, I noticed that it's then difficult to adjust the pitch of the aircraft manually to keep the same altitude, withjout disengaging the autopilot. Or I have to play with the trim instead of the yoke. But I need probably some more practice. When I flew this airplane in the real life, I never switched on the autopilot because I did'nt have any trust in it !!