AUTO Pressurisation Issue

[Deadmode]

Hi

The automatic pressurisation does not work at all. The cabin altitude seems to climb with the aircraft (no pressurisation). Controlling the pressurisation manually works absolutely fine.

I cannot find ANYTHING that could affect this. No doors open and using both FRESH or RECIRC air doesn't help, neither does APU or engine bleed sources. I am clueless to what's at play here.

Occurs every flight. Does anyone have any ideas on what could cause this and how I could fix it?

Thanks!

[Mark]

This isn't something we are able to replicate on our side. Could we kindly ask you to raise a ticket with Just Flight support via the following link: https://www.justflight.com/support

Included with the ticket, if you could provide details on the simulator being used, as well as a video of the behavior and/or steps on how to reproduce it, then that will allow our support team the best chance of being able to reproduce this behavior.

Mark - Just Flight

[dosendo]

Hello and Congratulations a wonderfull addons.

I have a similar problem like "Deadmode". I have done so far 5-6 flights without any problems this plane but until today as I take-off from EDDK to FL180 I found about 15 000 feet that MWS System Panel was Yellow warning light (Cabin Alt). It changed very soon to red. I try to find some help from the Manual but found nothing so I continue my flight to a destination airport ESMS.

I started normal procedures to descent and approach - no problems and about 7 000 feet red warning lights disappeared. Manual mode not working either. Any help?

[Derek]

@dosendo Could we kindly ask you to raise a ticket with Just Flight support via the following link: https://www.justflight.com/support

Included with the ticket, if you could provide details on the simulator being used, as well as a video of the behavior and/or steps on how to reproduce it, then that will allow our support team the best chance of being able to reproduce this behavior.

[dosendo]

Thank You!
Simulator is MSFS 2020 - to make video isn't familiar to me and procedures - I follow all steps that Tutorial flight of the Manual provide. I made my own checklist from Manual - a little bit shorter version but all steps observed. As I said earlier - 5-6 flight went nice and without any problems.

Anyway - I will to do a flight today and let see what happen.

[dosendo]

A little update:

Flight today -> ESMS-EDDM /FL180 -> MSFS 2020

I did everything like always following my Checklist. No problem at all. I don't know that about what went wrong yestarday. I had one other unusual event with FDR yestarday - there isn't a light at all as I cchecked it.

Thak You!