Grand duke - Cowl flap clickspot has wrong cursor in Legacy control mode
-
On the Grand Duke (I haven't tried the other two) in Legacy control mode (the plane I was in before this needed it) when I use the clickspot below the cowl flap switches to open them both at once my cursor changes to a 'restricted' circle with a line through it. The clickspot works ok, it just shows the wrong icon. The top clickspot to close them both at once correctly shows an up arrow, and of course in Lock mode it's not an issue.
-
Just adding to this thread to confirm it's still an issue. I've been meaning to post about it for a while but kept forgetting. I have tried going to the modern control mode a few times over the last four years of MSFS, but always end up going back to legacy (and often with tooltips disabled altogether).
Two issues to solve here, I believe:
- Clickspot has the wrong cursor for 'open' action
- Clickspot is too small - it's very difficult to get the mouse in the correct place ('close' clickspot is bigger)
Hope to see this addressed in a future update!