Default MSFS control assignments
-
Unless I'm missing something, the only info I see in the manual for the Dukes for mapping hardware is for more complex programs like A&O etc.
For those of us still doggedly bashing our heads against the wall with default MSFS control assignments, is there a table somewhere of which assignments correspond to which controls?
As of right now I am specifically looking to figure out how to bind:
- The CWS button the yoke
- The pitch knob on the autopilot
-
Pitch knob is in the thread immediately below this one :-)
I'm struggling bizarrely with assigning the piston mixture levers in spad next to the standard mixture axes - when I do and move the lever I hear something move somewhere but the mixture lever isn't it. I see there are LVARs for the engine controls but as throttle and pitch can be assigned to standard axes I'd expect mixture to be possibe too.
It's late so I will look with fresh eyes in the morning. I did of course fire it up and do a circuit at Sedona for science - very nice landing behaviour and the sounds are awesome :-)
-
@brennan said in Default MSFS control assignments:
Pitch knob is in the thread immediately below this one :-)
Thanks, but that's for people assigning via LVARs in programs like Spad and AAO, I'm trying to see if there's a binding for it in the default MSFS interface as asked in the original post.
-
@piedmonitor I have tried to find a default MSFS assignement, but unsuccefully for the time being. I hope there is an option, at least, to have a pitch knob assignement.
-
@Gilandred hmmm not for me. For me it's controling the pitch when the AP is engaged. Unfortunately the rocker switch doesn't animate when you do it, so it will look like it's not working. There's also an invisible click spot just to the right of the altitude selector, you might find that easier to use