Just Flight BAE 146 -300 Annoying and unusual sound in the cockpit
-
I bought this beauty at the market store from MSFS 2020. But I have a big problem.
Just Flight BAE 146 -300 Annoying unusual sound in the cockpit Microsoft Flight Simulator 2020
A strange sound is heard in the cockpit! This sound stops only when you hold down the right mouse button. It doesn't cut off in any way except for it!
in addition, an unusual strange sound is also heard in the external view too.
I have prepared a short video to explain this.
Before I brought this up, I checked to see if anyone had similar problems here and on the internet. I couldn't find anything.
https://www.youtube.com/watch?v=I091PwxDlK8Do you have any idea about the solution to the problem?
Otherwise, it cannot be used with this version. -
Are you using Honeycomb (or other brand yoke/TQ) ? It sounds like a hardware switch, where the sim is trying to give it another state.
-
@friese2020 said in Just Flight BAE 146 -300 Annoying and unusual sound in the cockpit:
Are you using Honeycomb (or other brand yoke/TQ) ? It sounds like a hardware switch, where the sim is trying to give it another state.
I use Thrustmaster H.O.T.A.S Warthog A-10C throttle, joystick, and rudder set. I didn't think of that option. I'll check it.
Thanks for your advice.
-
If you only have push-buttons, then probably the hardware is not causing the problem. I only know this "sound" with switches.
-
@friese2020 Thanks again for your advice. I couldn't control it. Because I'm starting to have problems opening up. The installation of the program began to take a very long time than usual. So I had to run it in safe mode and uninstall the last BAE146 I installed. When I have time, I'll reinstall it and try again. I'll share the result here.
-
@serhan I had a very similar symptom just now on the stand after landing. I finally figured it out - I must have hit the wrong button on my stick during taxi in and re-engaged the autopilot. The clicking noise was the trim wheel constantly moving. As soon as I disengaged the a/p - wheel stopped moving and the noise was gone :-)
I can see your a/p is not engaged and my noise was softer but it does lend credence to the binding theory....
