Bonanza A36 Ignition Starter Switch not working
-
Is anyone having issues staring the engine on both analogue A36 versions from Cold and Dark? The ignition starter switch is not working.
@sparky-0 You can't just use the mouse wheel to scroll over to the start position and expect it to go. You have to press and hold it in start until, well... It starts. Assuming you've primed the engine (Tank with fuel selected, mixture rich, full throttle, fuel pump high for 5ish seconds, then off), throttle to almost closed, and hit it!
Occasionally I've noticed it takes more than once, and the biggest uh oh I keep being guilty of doing is not pulling the throttle back to near idle after priming. If you have it all setup, you'll see the fuel flow dial go up to roughly 5ish gph. If you don't see that, something isn't' setup properly.
-
@sparky-0 You can't just use the mouse wheel to scroll over to the start position and expect it to go. You have to press and hold it in start until, well... It starts. Assuming you've primed the engine (Tank with fuel selected, mixture rich, full throttle, fuel pump high for 5ish seconds, then off), throttle to almost closed, and hit it!
Occasionally I've noticed it takes more than once, and the biggest uh oh I keep being guilty of doing is not pulling the throttle back to near idle after priming. If you have it all setup, you'll see the fuel flow dial go up to roughly 5ish gph. If you don't see that, something isn't' setup properly.
-
@kevykevtpa Many thanks, all good now. (It appears I was trying to move over to the start position as I do in the default MSFS G36 Bonanza).
Much appreciate your response.
@sparky-0 Glad I could help!
