146 Professional

Mobiflight has presets for mapping the TMS. Just select the "BAE146" and the "Autothrust System", and the code is there when you select one.

https://hubhop.mobiflight.com/presets/

I've also noticed it is very easy for the AP to (correctly) disconnect if you fly too slowly.

Engine management and use of flaps takes practice and experimentation on approach.

Depending on weight etc., I'm having to drop a notch of flaps close to 200 kias,and further flap extensions causes massive drag... as does the airbrake. As such it is very easy to drop below the yellow bug -- which of course I keep forgetting to set by clicking on the placard.

It's challenging- but good fun - to fly.

Yes. Quite normal.

I find the stock trim when using a pulse encoder wheel, a little too sensitive. But you can go into the system.cfg file, and reduce elevator trim sensitivity from 1.0 to 0.75.

I have just encountered the same issue.
I flew to EINN via the TIPUR 2D arrival. I manually set the VNAV to waypoint to GILOG. However, the distance calculation was still to TIPUR and the altitude calculation was to 6000ft:
before TIPUR
Passing TIPUR, the calculations were now correct to GILOG:
after TIPUR

Oh and BTW... the new FMS is awesome. 👍

Thank you Mark!

@Mark I will check again in which direction the switch moves exactly, but I always selected "Start" (Up). The problem is that the whole start sequence is not beginning, when it happens.

I wil check again abd report here, and maybe I can catch it on video.

Thank you

I am also having this issue, often finding it difficult to taxi in a straight line and makes taking off a little more fun.

I can't recall if I had it before.

Great news, thank you very much!

@Paulvanuf The original 146 tutorial flight remains the same in the V2 update (EGJJ-EGGP) but we have included an additional tutorial flight for the UNS-1 (NZAA-NZCH).

Mark - Just Flight

"Maybe it should be included in the manual"

It is; on page 77 under the heading of "Flight Controls".

Bruce R

Issue is confirmed to be caused by an update to the Horizon 787-9. A new update fixed the interference. It was the only recently updated mod I hadn't checked.

The advantage of Marketplace though is I can use it on my Xbox and then on a PC when I decide to upgrade at no extra cost.

So following on from this, now the UNS-1 FMS has released, will the PBN codes remain the same? My understanding is that the older UNS-1 is not RNAV1 compliant, again difficult to find the info.